Onkyo HT HT-S7300 Instruction Manual page 17

Connecting the Speaker Cables
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of
insulation from the ends of the
speaker cables, and twist the bare
wires tightly, as shown. (Supplied
speaker cables are already stripped.)
Using Banana Plugs
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
Push-type speaker terminals
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of
the speaker cables, and twist the bare wires tightly, as shown.
(Supplied speaker cables are already stripped.)
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURR BACK OR FRONT HIGH L terminals.
Speaker illustrations are based on HTP-680.
Surround Surround
back right back left
speaker speaker
Tan
Front high Front high
right left
speaker speaker
(Optional) (Optional)
* Using the supplied RCA cable, connect the subwoofer's LINE INPUT jack to your AV receiver's SUBWOOFER PRE OUT jack.
Note
• The front high speakers can also be connected to the SURR BACK OR FRONT HIGH SPEAKERS terminals. When doing so, set
"Surr Back/Front High" in Speaker Setup to "Front High"
1/2" to 5/8"(12 to 15 mm)
Surround Surround
right left
speaker speaker
Brown Gray
Powered
subwoofer
3/8" to 1/2"(10 to 12 mm)
Front right Front left
speaker speaker
Blue Red
(➔ 40).
Center speaker
White Green
En
17