Table of Contents
Advertisement
Parts needed for this step:
1 Weight—left
1 Weight—right
2 Weight brackets—left
2 Weight brackets—right
1 Support plate
4 Bolts, 3/8 x 6–1/2 inch
2 Bolts, 5/16 x 1 inch
8 Nuts, 3/8 inch
8 Lock washers, 3/8 inch
16 Flat washers, 3/8 inch
4 Bolts, 3/8 x 4–1/2 inch
2 Bolts, 3/8 x 3/4 inch
1 Self tapping bolt, 3/8 x 5/8 inch
Installing the Weights
Note: There are left hand and right hand weights and
weight brackets (Fig. 20).
Caution
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
Install the front weights.
1. Remove the two outside bolts that connect the front
floor pan to the carrier frame (Fig. 19). Save this
hardware.
2. Remove the 4 bolts and washers that hold the front floor
pan to the front frame (Fig. 19). Save this hardware.
6
4
1
8
7
3
5
Figure 19
1. Front floor pan
2. Footrest
3. Front frame
4. Bolt
3. With the two holes towards the front, place the left and
right–hand weight brackets onto the front frame
(Fig. 20).
4. In the weight bracket rear holes, install the weights with
4 bolts (3/8 x 6–1/2 inch), 8 flat washers (3/8 inch), 4
lock washers (3/8 inch), and 4 nuts (3/8 inch) (Fig. 20).
Note: Only the two inside weight brackets use the center
holes for installing the weights.
5. In the weight bracket center holes, install 2 bolts
(3/8 x 3/4 inch) into the weights (Fig. 20).
14
4
2
5
5
5. Nut
6. Washer
7. Front caster wheel
8. Carrier frame
m–6047
Advertisement
Table of Contents
