Table of Contents
Advertisement
Parts needed for this step:
1 Bolt, 1/2 x 1–3/4 inch
2 Jam nuts, 1/2 inch
Installing the Bagger Dump
Lever Stop Bolt
1. Move the bagger dump lever rearward to increase the
slack in the bagger cable (Fig. 26).
2. Remove the cotter pin and clevis pin securing the
bagger cable clevis to the bagger dump handle
(Fig. 26).
2
4
Figure 26
1. Bagger dump lever
2. Bagger cable
3. Bagger cable clevis
3. Thread a jam nut (1/2 inch) all the way onto the bolt
(1/2 x 1–3/4 inch) (Fig. 26).
4. Move the bagger dump lever forward to move the
bottom of the lever away from the stop bracket
(Fig. 26).
5. Insert the bolt into the stop bracket hole and thread
another jam nut (1/2 inch) onto the bolt. Do not tighten.
6. Secure the bagger cable clevis to the bagger dump
handle with the clevis pin and cotter pin previously
removed (Fig. 26).
7. Adjust the handle stop, refer to Adjusting the Bagger
Dump Lever, page 18.
3
1
6
5
4. Bolt, 1/2 x 1–3/4 inch
5. Jam nut, 1/2 inch
6. Stop bracket
No parts needed for this step.
Adjusting the Bagger Dump
Lever
The bagger lever needs to be adjusted to remove slack in
the bagger cable.
1. Loosen the nuts on both sides of the stop bracket
(Fig. 27).
2. Adjust the stop bolt until there is no slack in the bagger
cable (Fig. 27).
3. Tighten the nuts on both sides of the stop bracket
(Fig. 27).
1
4
m–6071
Figure 27
1. Bagger lever
2. Stop bracket
3. Stop bolt
18
1
5
2
5
3
4. Bagger cable
5. Nut
Advertisement
Table of Contents
