Table of Contents
Advertisement
Note: After the weights are installed, pivot the caster
wheels near the weights to ensure clearance between the
wheels and the weights. Adjust the weights if needed.
11
5
4
2
m–6048
Figure 20
1. Weight—left
2. Weight—right
3. Weight bracket—left
4. Weight bracket—right
5. Center hole
6. Rear hole
6. Install the two outside bolts that connect the front floor
pan to the carrier frame (Fig. 19).
7. Install only the top 2 bolts that hold the front floor pan
to the front frame (Fig. 19). Use existing hardware.
8. Using the bottom holes that hold the front floor pan,
install the support plate to the front of the machine with
2 new bolts (5/16 x 1 inch), 2 existing flat washers
(5/16 inch), and 2 existing flange nuts (5/16 inch)
(Fig. 22).
Note: If the right–hand flange nut can not be reached, drill
an 11/32 inch diameter hole through the front floor pan
using the support plate as a template (Fig. 21).
10
7
6
3
12
1
7
8
9
7. Flat washer, 3/8 inch
8. Lock washer, 3/8 inch
9. Nut, 3/8 inch
10. Bolt, 3/8 x 6–1/2 inch
11. Bolt, 3/8 x 3/4 inch
12. Front frame
15
2 2
3
5
Figure 21
1. Flange nut, 5/16 inch
2. Bolt, 5/16 x 1 inch
3. Existing flat washer,
5/16 inch
9. Using the support plate as a template, drill one
5/16 inch hole into the front floor pan (Fig. 22).
10. Install a self tapping bolt (3/8 x 5/8 inch) into support
plate and hole just drilled (Fig. 22).
11. Install the support plate to the brackets and weights with
4 bolts (3/8 x 4–1/2 inch), 8 flat washers (3/8 inch), 4
lock washers (3/8 inch), and 4 nuts (3/8 inch) (Fig. 22).
12
11
8
11
12
10
5
6
4
Figure 22
1. Weight
2. Bolt, 3/8 x 4–1/2 inch
3. Support plate
4. Nut, 3/8 inch
5. Flat washer, 3/8 inch
6. Lock washer, 3/8 inch
7. Flange nut
6
1
4
m–6111
4. Front floor pan
5. Support plate
6. Hole to drill if needed
2
5
3
9
1
7
m–6050
8. Self tapping bolt,
3/8 x 5/8 inch
9. Hole to drill
10. Front caster wheel
11. Bolt, 5/16 x 1 inch
12. Existing flat washer,
5/16 inch
Advertisement
Table of Contents
