Table of Contents
Advertisement
Parts needed for this step:
1 Bagger
2 Clevis pins
2 Hairpin cotters
Installing the Bagger
1. Install the bagger onto the bagger mounting bracket
(Fig. 14).
2. Install clevis pins into the bagger and bagger mounting
bracket. Secure them with hairpin cotter pins (Fig. 14).
1
2
Figure 14
1. Bagger
2. Bagger mounting bracket
3
4
m–6032
3. Hairpin cotter pin
4. Clevis pin
12
Parts needed for this step:
1 Bagger belt
Installing the Bagger Belt
1. Remove the 2 wing nuts (5/16 inch) securing the pulley
guard to the bottom of the bagger (Fig. 15).
2
2
Figure 15
1. Pulley guard
2. Install the bagger belt onto the clutch drive pulley
(Fig. 16).
3. Route the bagger belt onto the idler pulley (Fig. 16).
4. Route the bagger belt through the hole in the rear
bumper (Fig. 16).
5. Route the bagger belt onto the bagger pulley (Fig. 16).
6. Connect the spring loop to the hook on the idler arm
(Fig. 16).
1
2. Wing nut, 5/16 inch
Advertisement
Table of Contents
