Installing The Weights - Toro Reelmaster 3555 Series Installation Instructions Manual

as well as any 6 mm (1/4 inch) spacers
positioned on the top side of the side-plate
mounting flange
Note:
Do not remove the bolts. Keep the flange
locknuts and washers for future assembly.
5. Position the left or right roller-brush-assembly
mounting brackets onto the roller-bracket bolts
(Figure 4).
1. Left roller-brush assembly
Important:
Attach the mounting brackets
for the roller-brush assembly directly to
the top surface of the side-plate mounting
flange of the cutting unit. Do not put spacers
between the roller-brush mounting brackets
and the side-plate mounting flanges. Save
the additional 6 mm (1/4 inch) spacers for
potential later use.
6. Secure the brush-assembly mounting brackets
to the cutting-unit side plates with the previously
removed nuts.

Installing the Weights

Install the appropriate weights to the cutting units.
•
5-inch hydraulic cutting units: as shown in
5; parts included with Brush Kit (Model 03658).
•
5-inch electric cutting units: need Weight Kit
(Model 03419) as shown in
weight and fasteners included with the brush kit
(do not use).
•
7-inch hydraulic and electric cutting units: need
Weight Kit (Model 03419) as shown in
Brush Kit (Model 03659).
(Figure 3).
Figure 4
2. Roller-brush mounting
bracket
Figure 6, discard the
Figure 6
Weight Included with Brush Kit (Model 03658)
1. Weight plate
2. Carriage bolts (5/16 x 1
inch)
g032172
1. Weight plate
2. Carriage bolts (5/16 x 2
inch)
3. Bolts (5/16 x 1/2 inch)
Figure
for
3
Figure 5
3. Flange nuts (5/16 inch),
torque to 20 to 26 N∙m (15
to 19 ft-lb)
4. Weight
Figure 6
Weight Kit (Model 03419)
4. Washers (5/16 inch)
5. Flange nuts (5/16 inch)
6. Weight
g032167
g032168