Installing The Bagger Mounting Bracket - Toro 78500 Operator's Manual

Parts needed for this step:
1 Bagger mounting bracket
16 Bolts, 5/16 x 1 inch
16 Flange nuts, 5/16 inch
6 Flat washers, 5/16 inch
Installing the Bagger Mounting
Bracket
Important Do not tighten any bolts until all bolts are
loosely installed for the bagger mounting bracket.
1. Loosely install the bagger mounting bracket to the back
of the rear bumper and the engine guard straps, with 8
bolts (5/16 x 1 inch) and 8 flange nuts (5/16 inch)
(Fig. 9).
5
2
Figure 9
1. Bagger mounting bracket
2. Bolt, 5/16 x 1 inch
3. Flange nut, 5/16 inch
3
4
1
4. Back of rear bumper
5. Engine guard strap
10
2. Loosely install the bagger mounting bracket to the side
of the rear bumper and the engine guard straps, with 8
bolts (5/16 x 1 inch), 6 flat washers (5/16 inch), and
8 flange nuts (5/16 inch) (Fig. 10).
Note: The bagger mounting bracket is to be installed to the
inside of the engine guard straps.
4
6
2
3
1
Figure 10
1. Bagger mounting bracket
2. Bolt, 5/16 x 1 inch
3. Flat washer, 5/16 inch
3. When all bolts, washers, and nuts are installed, tighten
them. Torque all mounting bolts to 230 in–lb (26 N m).
5
3
2
m–7648
4. Flange nut, 5/16 inch
5. Side of rear bumper
6. Engine guard strap