Installing The Bagger Idler Pulley And The Skid Plate - Toro 78500 Operator's Manual

Parts needed for this step:
1 Idler pulley assembly with bracket
5 Bolts, 5/16 x 7/8 inch
5 Flange nuts, 5/16 inch
1 Spring bracket
1 Skid plate
1 Shoulder bolt, 3/8 x 2–1/2 inch
1 Flange nut, 3/8 inch
1 Spring
Installing the Bagger Idler
Pulley and the Skid Plate
1. Install the spring bracket to the rear bumper with 2
bolts (5/16 x 7/8 inch) and 2 flange nuts (5/16 inch)
(Fig. 11).
3
Figure 11
1. Spring bracket
2. Rear bumper
2. Install the skid plate and idler pulley bracket to the rear
bumper with 3 bolts (5/16 x 7/8 inch) and 3 flange nuts
(5/16 inch) (Fig. 12).
3. Install the skid plate to the bottom of the rear bumper
with 2 bolts (5/16 x 7/8 inch) and 2 flange nuts
(5/16 inch) (Fig. 12).
1
4
2
3. Bolt, 5/16 x 7/8 inch
4. Flange nut, 5/16 inch
1
4
Figure 12
1. Skid plate
2. Idler pulley bracket
3. Rear bumper
4. Install the shoulder bolt (3/8 x 2–1/2 inch), spring and
flange nut (3/8 inch) to the spring bracket (Fig. 13).
3
4
Figure 13
1. Spring bracket
2. Shoulder bolt, 3/8 x
2–1/2 inch
11
2
5
3
4. Bolt, 5/16 x 7/8 inch
5. Flange nut, 5/16 inch
1
2
3. Flange nut, 3/8 inch
4. Spring