Features Learning Commands From Other Remote Controllers - Onkyo TX-SR603X Instruction Manual

Controlling Other Components
Learning Commands from Other
Remote Controllers
The AV receiver's remote controller can receive and
learn commands from other remote controllers. By
transmitting, for example, the Play command from your
CD player's remote controller, the remote controller can
learn it and then transmit the exact same command when
its Play [ ] button is pressed in CD mode.
You can also use this function to learn individual com-
mands after entering a remote controller code (page 78).
ON STANDBY
1
I
V1 V2 V3
1 2
3
V4 MULTI CH DVD
4 5 6
CD TAPE TUNER
7 8 9
+ 10 0
CLEAR
10 11
- - / - - -
INPUT SELECTOR
MACRO
1 2
REMOTE MODE
RECEIVER DVD CD
1, 4
TAPE/AMP
TV VCR CABLE
CDR
DIMMER
+
CH
DISC ENTER
ALBUM
-
PREV
CH
DISPLAY
1 While holding down the REMOTE
MODE button for the mode in
REMOTE MODE
which you want to use the com-
RECEIVER DVD
TAPE/AMP
mand, press the [ON] button.
CD HDD
The Remote indicator lights up.
TV VCR
CABLE SAT
CDR MD
ON
2
On the AV receiver's remote con-
troller, press the button you want
to learn the new command.
Remote
indicator
TV
INPUT
+
TV CH
-
TV VOL
12
3
ZONE2
HDD
SAT
MD
SLEEP
VOL
MUTING
3 Point the remote controllers at
each other, about 2 to 6 inches
(5–15 cm) apart, and then press
and hold the button whose com-
mand you want to learn until the
Remote indicator flashes.
If the command is learned successfully,
the Remote indicator flashes twice.
About 2 to 6
inches (5–15 cm)
4
To learn more commands, repeat
steps 2 and 3.
Press any REMOTE MODE button
when you've finished.
Notes:
• The following buttons cannot learn new commands:
REMOTE MODE, MACRO [1], [2], [3], TV [
TV CH [+]/[–], TV [INPUT], TV VOL [
• The AV receiver's remote controller can learn approx-
imately 70–90 commands, although, this will be
reduced by commands that use a lot of memory.
• Remote controller buttons such as Play, Stop, Pause,
and so on are preprogrammed with commands for
controlling Onkyo CD players, cassette decks, and
DVD players. However, they can learn new com-
mands, and you can restore the preprogrammed com-
mands by resetting the remote controller (page 79).
• To overwrite a previously learned command, repeat
this procedure.
• Only commands from infrared remote controllers can
be learned.
• When the remote controller's batteries expire, all
learned commands will be lost and will have to be
learned all over again, so don't discard your other
remote controllers.
RC-623M
],
]/[ ].
81