Programming The Commands Of Remote Controllers For Other Devices Into The Remote Controller - Onkyo TX-DS595 Instruction Manual

Programming the commands of remote controllers
for other devices into the remote controller
C H
DISC
AUDIO
ANGLE
TV / VCR
LEVEL
RANDOM
REC
DVD
V 1 V 2
V 3 V 4
STEREO DIRECT
1
SURR
4
SP A
7
DISPLAY DIMMER
+10
-- / ---
HOME THEATER CONTROLLER
RC-447M
42
5 to 15 cm
(2 to 6 inches)
SEND/LEARN
indicator
MODE
buttons
VOL
MUTING
SUBTITLE
OPEN / CLOSE
C D
T 1 T 2
TUN P H
DSP
2 3
A.ST DSP
5 6
SP B Re-EQ
8 9
ZONE 2
ENTER
0 SEARCH
ENTER
Programming procedure
When programming the commands of another remote controller to
the RC-447M remote controller, you must first decide under which
MODE button you want the commands to be linked. In general, you
will select the MODE button that corresponds to the component you
are programming. For example, if you are programming the
functions from a remote controller for a compact disc player, you
would choose the CD MODE button. Then, by pressing the CD
MODE button, the buttons on the RC-447M remote controller will
change to the commands you program here to operate the compact
disc player.
After programming which MODE button to use, you will then
transfer the separate commands from the other remote controller
over to the RC-447M remote controller one at a time. Each
command is then programmed to a different button on the RC-447M
remote controller. Any button is programmable for this step except
for the eight MODE buttons (RCVR, CD, DVD, MD, SAT, CABLE,
VCR, and TV) and the two MACRO buttons (DIRECT and MODE).
Even after the commands have been memorized, keep your old
remote controller in a safe place. If for some reason the commands
are lost (e.g., when the batteries run down), it will be necessary to
memorize them once again.
1. Place the remote controller and the remote controller
for the other device facing each other at a distance of
5 to 15 cm (2 to 6 inches) apart.
2. While pressing and holding down the desired MODE
button on the remote controller, press the ENTER
button and then release both buttons.
When you press and hold down the MODE button, the SEND/
LEARN indicator lights. When you press the ENTER button, the
lamp turns off. When you release the buttons, the lamp lights
again.
3. Press and release the button on the remote controller
to which you want to transfer the next command.
You may select any button but the ten ones indicated in the
figure below. When you press the button, the SEND/LEARN
indicator turns off. When you release the button, the indicator
lights again.
If you press the wrong button by mistake, press that same button
again. The SEND/LEARN indicator flashes twice, and the
remote controller exits the programming mode.
DIRECT MACRO
CH
:
Buttons that cannot be programmed.
MODE MACRO
MODE buttons