Onkyo TX-SR603X Instruction Manual page 67

Advanced Operations
AV Recording
You can record AV input sources to an AV recording
component (VCR, etc.) connected to the VIDEO 1 OUT,
VIDEO 2 OUT, or TAPE OUT. See pages 26–36 for
information on connecting components.
STANDBY/ON
STANDBY
ZONE2 OFF
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT
ZONE 2 LEVEL
PHONES
MULTl CH DVD VIDEO 1 VIDEO 2 VIDEO 3
VCR 1 VCR 2
1
Use the input selector buttons to
select the AV component that
DVD VIDEO 1 VIDEO 2
you want to record.
Audio signals from the selected input
VCR 1 VCR 2
VIDEO 3 VIDEO 4 TAPE source are output by the VIDEO 1
OUT, VIDEO 2 OUT, and TAPE OUT
only.
TUNER CD
You can watch the source while record-
ing, and the AV receiver's VOLUME
control has no effect on recording.
2 Start recording on the AV compo-
nent connected to the VIDEO 1
OUT, VIDEO 2 OUT, or TAPE OUT.
3 Start playback on the source AV
component.
If you select another input source dur-
ing recording, that input source will be
recorded.
1
MASTER VOLUME
TUNING / PRESET
ENTER
RETURN SETUP
DIMMER MEMORY TUNING MODE
CLEAR
VIDEO 4 INPUT
VIDEO 4 TAPE TUNER CD
SETUP MIC S VIDEO VIDEO L AUDIO R DIGITAL
Recording Separate AV Sources
Here you can record audio and video from completely
separate sources, allowing you to overdub audio onto
your video recordings. This function takes advantage of
the fact that when an audio-only input source (i.e.,
TAPE, TUNER, or CD) is selected, the video input
source remains unchanged.
In the following example, audio from the CD player con-
nected to the CD IN, and video from the camcorder con-
nected to the VIDEO 4 INPUT VIDEO jack are recorded
by the VCR connected to the VIDEO 1 OUT jacks.
VIDEO 4 INPUT
S VIDEO VIDEO L AUDIO R DIGITAL
IR IN
12 V TRIGGER OUT
ZONE 2
DIGITAL
COAXIAL
IN 1
COMPONENT VIDEO
IN 3 IN 2 IN 1 OUT
Y
IN 2
OPTI- P
B
CAL
IN 1
P R
IN 2
IN 3
IN OUT IN
L
OUT
R
REMOTE
CONTROL
CD TAPE
CD player
1
Prepare the camcorder and CD player for
playback.
2
Prepare the VCR for recording.
3 Press the [VIDEO 4] input selector button.
4 Press the [CD] input selector button.
This selects the CD player as the audio source, but
leaves the camcorder as the video source.
5
Start recording on the VCR and start play-
back on the camcorder and CD player.
The video from the camcorder and the audio from
the CD player are recorded by the VCR.
Camcorder
video signal
audio signal
AV RECEIVER
TX-SR 603X
MODEL NO.
ZONE 2 SURRO
SPEAKERS SPE
ANTENNA AM FM 75
L
MONITOR
VIDEO 3 VIDEO 2 VIDEO 1 DVD OUT
L
V
R
R
S
IN OUT IN OUT IN IN ZONE 2
LINEOUT PRE OUT
IN OUT IN OUT IN FRONT SURROUND CENTER
SUB
L
WOOFER
R
SUB
WOOFER
VIDEO 3 VIDEO 2 VIDEO 1 DVD
VCR
67