Resetting The Remote Controller - Onkyo TX-SR603X Instruction Manual

Controlling Other Components
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Onkyo component is con-
nected with an
audio cable (RCA).
See page 36 for details.
2
Enter the appropriate remote control code
for the REMOTE MODE button.
• [DVD] REMOTE MODE button
5002: Onkyo DVD player with
• [CD] REMOTE MODE button
6002: Onkyo CD player with
• [MD] REMOTE MODE button
6008: Onkyo MD recorder with
• [CDR] REMOTE MODE button
6006: Onkyo CD recorder with
See the previous page for how to enter remote
control codes.
3 Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via
the following remote control codes:
• [DVD] REMOTE MODE button
5001: Onkyo DVD player without
• [CD] REMOTE MODE button
6001: Onkyo CD player without
• [MD] REMOTE MODE button
6007: Onkyo MD recorder without
• [CDR] REMOTE MODE button
6005: Onkyo CD recorder without
Note:
If you connect an -capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote opera-
tion to work properly, you must set the display to MD or
CDR (see page 50).
are con-
cable and an analog
, use
(default)
(default)
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
1 While holding down the REMOTE
MODE button that you want to
REMOTE MODE
reset, press the TV [
CD DVD
The Remote indicator flashes three
TV VCR
times.
CABLE SAT
CDR MD
2
Press the REMOTE MODE button
again.
The Remote indicator flashes twice,
REMOTE MODE
CD DVD indicating that the button has been
reset.
TV VCR
CABLE SAT
CDR MD
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers respectively. When these buttons
are reset, the preprogrammed code is
restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down the
RECEIVER [RECEIVER] REMOTE MODE but-
ton, press the [STANDBY] button.
The Remote indicator flashes five
STANDBY times.
2
Press the [RECEIVER] REMOTE
MODE button again.
RECEIVER
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
] button.
79