Connecting Components; Connecting The Power Cord Of Another Component - Onkyo TX-SR603X Instruction Manual

Connecting the AV Receiver
Connecting
With (Remote Interactive) you can control your
-compatible Onkyo CD player, DVD player, and so
on with the AV receiver's remote controller, as follows:
• To use , you must make an analog audio con-
nection between the AV receiver and the other AV
components, even if they are connected digitally.
Auto Power On/Standby
When you start playback on an AV component con-
nected via , if the AV receiver is in Standby, it will
turn on and select that AV component as the input source
automatically. Similarly, when the AV receiver is set to
Standby, all components connected via
Standby. Note that this function will not work if the com-
ponent's power cord is connected to the AV receiver's
AC OUTLET.
Direct Change
When playback is started on an AV component con-
nected via , the AV receiver automatically selects
that AV component as the input source.
Remote Control
You can control your
nents with the AV receiver's remote controller.
IR IN
12 V TRIGGER OUT
ZONE 2
DIGITAL
COAXIAL
IN 1
COMPONENT VIDEO
IN 3 IN 2 IN 1
Y
IN 2
OPTI- P
B
CAL
IN 1
P
R
IN 2
IN 3
IN OUT
L
OUT
R
REMOTE
CONTROL
CD
IN
L
R
AUDIO
e.g., DVD player
OUTPUT
L
R
e.g., MD recorder
AUDIO
OUTPUT
L
R
Notes:
• If you connect an
recorder or CD recorder to the TAPE IN/OUT jacks,
for to work properly, you must change the
TAPE/MD/CDR display (see page 50).
• Push plugs in all the way to make good connections.
• Use only cables for
cables are supplied with this AV receiver.
• Some AV components have two
connect either one to this AV receiver. The other jack
is for connecting more
• Connect the AV receiver's
components. Connecting to other manufacturer's AV
components may cause them to malfunction.
• Some components may not support all
Refer to the manuals supplied with your components.
36
Components
also enter
-compatible Onkyo compo-
AV RECEIVER
MODEL NO. TX-SR 603X
ZONE 2 SURROUND BACK REMOTE
SURROUND SPEAKERS FRONT SPEAKERS
SPEAKERS SPEAKERS
ANTENNA AM FM 75
OUT CONTROL
L L
MONITOR
VIDEO 3 VIDEO 2 VIDEO 1 DVD OUT
V L
R
R R
S
IN OUT IN OUT IN IN ZONE 2
LINEOUT PRE OUT
IN IN OUT IN OUT IN FRONT SURROUND CENTER
SUB
L
WOOFER
R
SUB
WOOFER
CENTER SPEAKER
TAPE VIDEO 3 VIDEO 2 VIDEO 1 DVD
IN
L
R
-compatible Onkyo MiniDisc
connections. No
jacks. You can
-compatible components.
jack to only Onkyo AV
functions.
Connecting the Power Cord of
Another Component
The AV receiver has an AC outlet on its rear panel for
connecting the power cord of another AV component.
The other component's power switch can then be left in
the ON position so that it turns on or off when the AV
receiver is set to On or Standby.
Caution:
Make sure that the capacity of the component that you
connect to the AC OUTLET does not exceed the stated
capacity (e.g., 120 W).
Notes:
• Onkyo components with
nected directly to wall outlets, not the AV receiver's
AC OUTLET.
• The socket type and capacity will depend on the coun-
try in which you purchased the AV receiver.
AC OUTLET
AC 120V 60 Hz
SWITCHED
120W 1A MAX.
jacks should be con-