Entering Remote Control Codes - Onkyo TX-SR603X Instruction Manual

Controlling Other Components
You can use the AV receiver's remote controller
(RC-623M) to control your other AV components,
including those made by other manufacturers.
This section explains how to:
• Enter the remote control code for a component that
you want to control (e.g., DVD, TV, VCR).
• Learn commands directly from another component's
remote controller (see page 81).
• Program the MACRO buttons to perform a sequence
of up to eight actions (see page 82).

Entering Remote Control Codes

Entering a remote control code for a REMOTE MODE
button allows you to control an other component with the
remote controller. You'll need to enter a code for each
component that you want to control.
STANDBY
ON
Number
buttons
CD
+ 10
- - / - - -
RECEIVER
RECEIVER
TAPE/AMP
TV
DIMMER
+
CH
DISC
ALBUM
-
PREV
CH
DISPLAY
REC
STEREO
REPEAT
TEST TONE
OPEN/CLOSE
1
Look up the appropriate remote
control code in the Remote Con-
trol Codes list.
The codes are organized by category.
78
Remote
indicator
STANDBY
TV
INPUT
I
TV
V1 V2 V3
+
1 2 3
TV CH
V4 MULTI CH DVD
4 5 6 -
TAPE TUNER
7 8 9
TV VOL
0 CLEAR
10 11 12
INPUT SELECTOR
MACRO
1 2 3 ZONE2
REMOTE MODE
REMOTE
DVD CD HDD
MODE
VCR CABLE SAT
CDR MD
SLEEP
ENTER VOL
MUTING
PLAYLIST RANDOM
LISTENING MODE
SURR
AUDIO SUBTITLE PLAY MODE
DIRECT ALLST
CH SEL LEVEL LEVEL
VIDEO OFF
L NIGHT CINE FLTR
RC-623M
2
REMOTE MODE
CD DVD
TV VCR
CABLE SAT
CDR MD
STANDBY
3
I
4
Notes:
• Remote control codes cannot be entered for the
[RECEIVER], [HDD], and [ZONE 2] REMOTE
MODE buttons.
• The remote control codes provided are correct at the
time of printing, but are subject to change.
• The HDD remote mode can only be used with the
Onkyo DS-A1 Remote Interactive Dock at this
time.
• The [DVD] and [CD] REMOTE MODE buttons
are preprogrammed for use with Onkyo DVD
players and CD players respectively.
• To control another manufacturer's CD recorder or
MD recorder, enter the appropriate control code to
the [CD] REMOTE MODE button.
While holding down the REMOTE
MODE button that you want to
set, press the [STANDBY] button.
The Remote indicator lights up.
Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The Remote indicator flashes twice.
Press the REMOTE MODE button
again to select the remote con-
troller mode, point the remote
controller at the component, and
operate it.
If the remote controller doesn't work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.