Turning On The Av Receiver - Onkyo TX-SR603X Instruction Manual

Connecting the AV Receiver

Turning On the AV Receiver

• Before connecting the power cord, connect all your
speakers and AV components.
• Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different circuit.
STANDBY indicator
To wall outlet
STANDBY/ON
1 Plug the power cord into an AC
wall outlet.
The STANDBY indicator will light up.
STANDBY
2
Press the [STANDBY/ON] button.
Alternatively, press the remote
STANDBY/ON
controller's [RECEIVER] button
followed by the [ON] button.
The AV receiver comes on, the display
lights up, and the STANDBY indicator
Remote
goes off.
controller
ON
STANDBY
To turn off the AV receiver, press the
[STANDBY/ON] button. The AV
receiver will enter Standby mode.
Notes:
• Pressing the remote controller's [ON] button once will
turn on the AV receiver. Pressing it again will turn on
any components connected via
• When the AV receiver is on Standby, it will turn on
automatically when any one of its input selector but-
tons is pressed.
• Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.
ON
STANDBY
ON STANDBY
TV
I INPUT
V1 V2 V3
+
1 2 3
MULTI CH DVD TV CH
V4
4 5 6 -
CD TAPE TUNER
7 8 9
TV VOL
+ 10
0 CLEAR
10 11 12
--/---
INPUT SELECTOR
.
37