Changing The Input Display - Onkyo TX-SR603X Instruction Manual

First Time Setup

Changing the Input Display

If you connect an
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 3 IN
jacks, for to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
STANDBY/ON
STANDBY
ZONE2 OFF
TONE + STEREO
ZONE 2 LEVEL
PHONES
MULTl CH DVD VIDEO 1
VCR 1
1, 2
iPod photo: If you're using an iPod photo with the
DS-A1 Remote Interactive Dock, connect the DS-A1 to
the VIDEO 3 IN jacks.
1 Press the [TAPE] or [VIDEO 3]
input selector button so that
TAPE
"TAPE" or "VIDEO 3" appears on
the display.
VIDEO 3
2
Press and hold down the [TAPE]
or [VIDEO 3] input selector but-
TAPE
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
HDD.
VIDEO 3
For the TAPE input selector, the setting
changes in this order:
TAPE
For the VIDEO 3 input selector, the set-
ting changes in this order:
VIDEO 3
Note:
HDD can be selected for the TAPE input selector or
VIDEO 3 input selector, but not both at the same time.
50
-capable Onkyo MiniDisc
MASTER VOLUME
TUNING / PRESET
ENTER
RETURN SETUP
LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
CLEAR
VIDEO 4 INPUT
VIDEO 2 VIDEO 3 VIDEO 4 TAPE TUNER CD
VCR 2 SETUP MIC S VIDEO VIDEO L AUDIO R DIGITAL
1, 2
→ → →
MD CDR HDD
↔
HDD