Connecting Components Without Hdmi - Onkyo TX-RZ900 Basic Manual

Control) compliant device, connection with ARC compatible
TV, and HDMI Standby Through function. See "2 Source
Connection" of "Step 2: Initial Setup".
･ Another TV can be connected to the HDMI OUT
SUB jack. In this case, press the HDMI OUT button
on the main unit several times to display "SUB" or
"MAIN+SUB" and select the output method. You have to
modify the settings to enable the CEC functions, such
as ARC, for the TV connected to the HDMI OUT SUB
jack. Set "Step 3: Playing Back" - "7 Quick Setup menu"
- "Control TV" to "SUB".
･ To enjoy HDCP2.2 protected video, connect the player
to one of the HDMI IN1 to IN5 jacks and connect
the HDMI output jack on this unit and to a HDCP2.2
compatible HDMI input jack on the TV. You will be
unable to view images protected by HDCP2.2 if your TV
does not have a HDCP2.2 compatible input jack.
･ To play 4K or 1080p video, use a high speed HDMI
cable or high speed HDMI with Ethernet cable.
En-10

Connecting Components without HDMI

If your AV component does not have HDMI jack, use an
available jack of your component for cable connection with
this unit.
＊ It is possible to change assignment of the input jacks and input selector
buttons. For how to make settings, see "1. Input/Output Assign" in
"Advanced Settings (Setup Menu)" in the Advanced Manual.
3 2
5 4
■ Video signal connection
The unit has a video upconversion function. For details,
see the next section.
A TV with component video input jacks or a player with
1
component video output jacks can be connected.
＊ Only images input through the COMPONENT VIDEO IN jacks can be
output through the COMPONENT VIDEO OUT jacks.
Component video cable
1
＊ Its transmitted video has higher quality than
that of composite video cable.
A TV with composite video input jacks or a player with
2
composite video output jacks can be connected.
＊ Only images input through the VIDEO IN jack (composite) can be
output through the VIDEO OUT jack.
Composite video cable
■ Audio signal connection
A player with a digital audio out jack can be connected.
3
Digital optical cable (OPTICAL)
＊ The DIGITAL IN OPTICAL jack of the unit has
a cover. Push in the cable against the cover
as it is turned inside.
Digital coaxial cable (COAXIAL)
A player with analog audio out jacks can be connected.
4
When using jacks 1 and 2 for video input, connect
to the audio input jacks corresponding to the jacks
connected at 1 and 2. (For example, when video input
connection is to the 1 BD/DVD jack, the audio input
connection should also be to the 4 BD/DVD jacks.)
Analog audio (RCA) cable
Connect a turntable that uses an MM type cartridge
5
and does not have a built-in audio equalizer. If the
connected turntable has a built-in audio equalizer,
connect it to the 4 analog audio input jack.
＊ If it uses an MC type cartridge, install an audio equalizer compatible
with MC type cartridge between the unit and the turntable by
connecting it to the 4 analog audio input jack. For details, refer to
the turntable's instruction manual.
＊ If the turntable has a ground wire, connect it to the GND terminal of
this unit. If connecting the ground wire increases noise, disconnect it.
Step 1: Connections