Table of Contents
Advertisement
STORAGE
NOTE
Ignition switch should be in the "OFF" position
while pulling the recoil cord, and performing storage
maintenance steps .
Storage
For long term storage, please follow these guidelines .
Engine Storage
1 . Allow the engine to cool completely before storage .
2 . Clean the engine according to the instructions in the
Maintenance section .
3 . Drain all fuel completely from the fuel line and
carburetor to prevent gum from forming .
4 . Add a fuel stabilizer into the fuel tank .
5 . Change the oil .
6 . Remove the spark plug and pour about ½ ounce
of oil into the cylinder . Crank the engine slowly to
distribute the oil and lubricate the cylinder .
7 . Reattach the spark plug .
Pressure Washer Storage
1 . Allow the pressure washer to cool completely before
storage .
2 . Turn off the fuel supply at the fuel valve .
3 . Clean the pressure washer according to the
instructions in the Maintenance section .
4 . Store the unit in a clean, dry area out of direct sunlight .
DANGER
Engine exhaust contains odorless and colorless
carbon monoxide gas .
To avoid accidental or unintended ignition of your
remote start generator during periods of storage,
the following precautions should be followed:
– When storing the generator for short periods of
time make sure that the Ignition Switch, the Fuel
Valve and the Battery Switch are set in the OFF
position .
– When storing the generator for extended periods
of time make sure that the Ignition Switch, the
Fuel Valve and the Battery Switch are set in the
the the OFF position and the battery leads have
been disconnected from the battery .
17
REV 71320-20120305
Disconnect the battery
1 . Remove the protective cover from the black/negative
battery lead .
2 . Disconnect the black/negative lead from the black/
negative terminal on the battery and store the cap
screw (M5x10) and lock washer (M5) .
3 . Repeat steps 1-2 for the red/positive battery lead .
4 . Store the battery in a cool, dry place .
Charge the battery
For pressure washers equipped with batteries for electric
starting, proper battery maintenance and storage
should be followed . An automatic battery charger with
automatic trickle charging capability should be used to
charge the battery . Maximum charging rate should not
exceed 1 .5 amps . Follow the instructions included with
the battery charger . The battery should be fully charged
at least once per month .
NOTE
A Float Charger will maintain the battery condition
over long storage periods .
Winter Storage
Protect your pressure washer parts from freezing .
1 . Apply all storage instructions from previous sections .
2 . Make sure pressure washer hose is free of all water
before storing for winter .
3 . In order to prevent the pump from freezing you will
need to insert RV antifreeze .
4 . You will need approximately 6 ounces of RV
Antifreeze, a funnel, and approximately 12" of
garden hose or equivalent . See diagram below .
5 . Pour the antifreeze into the funnel, then pull on the
engine recoil starter to create suction in the pump
housing . Pull the recoil several times until antifreeze
comes out of the pump outlet .
71320
ENGLISH
Advertisement
Table of Contents
