Table of Contents
Advertisement
OWNER'S MANUAL & OPERATING INSTRUCTIONS
2650 PSI / 2.3 GPM
PRESSURE WASHER
MODEL NUMBER
75520
10006 Santa Fe Springs Road
SAVE THESE INSTRUCTIONS
Santa Fe Springs CA 90670
Important Safety Instructions
USA / 1-877-338-0999
MADE IN CHINA
are included in this manual.
REV 75520-20121219
www.championpowerequipment.com
Advertisement
Table of Contents
Related Manuals for Champion Power Equipment 75520
Summary of Contents for Champion Power Equipment 75520
- Page 1 2650 PSI / 2.3 GPM PRESSURE WASHER MODEL NUMBER 75520 10006 Santa Fe Springs Road SAVE THESE INSTRUCTIONS Santa Fe Springs CA 90670 Important Safety Instructions USA / 1-877-338-0999 MADE IN CHINA are included in this manual. REV 75520-20121219 www.championpowerequipment.com...
- Page 2 Have questions or need assistance? Do not return this product to the store! WE ARE HERE TO HELP! Visit our website: www.championpowerequipment.com for more info: • Product Info & Updates • Tech Bulletins • Frequently Asked Questions • Product Registration –...
-
Page 3: Table Of Contents
75520 2650 PSI / 2.3 GPM PRESSURE WASHER TAblE Of CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -
Page 4: Introduction
Introduction Accessories Congratulations on your purchase of a Champion Power Champion Power Equipment manufactures and sells Equipment pressure washer . CPE designs and builds accessories designed to help you get the most from pressure washers to strict specifications . With proper your purchase . -
Page 5: Manual Conventions
. Please call our help line at situation which, if not avoided, could result in 1-877-338-0999 death or serious injury . CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury . REV 75520-20121219... -
Page 6: Safety Rules
• DO NOT remove fuel tank cap or fill fuel tank while engine is hot or running (allow engine to cool two minutes before refueling) . Always fill the tank slowly . • Never disconnect the high pressure discharge hose from the machine while the system is pressurized . REV 75520-20121219... - Page 7 . – Equipment sparks, smokes or emits flames – Equipment vibrates excessively CAUTION NEVER run the unit dry . Be sure the water supply is completely turned on before operating the unit . REV 75520-20121219...
-
Page 8: Controls And Features
Recoil Starter – Used to manually start the engine . power washing . Engine Switch (11) High Pressure Hose Connection Fuel Valve Knob – Used to turn fuel supply on and (12) Garden Hose Connection off to engine . (13) 10 in. Never Flat Tires Choke REV 75520-20121219... -
Page 9: Parts Included
75520 ENGLISH CONTROlS AND fEATURES Parts Included Your 75520 Gasoline Powered Pressure Washer ships with the following parts: Gun Assembly – Pressure Gun . . . . . . . . . . . . . . . . . . . . . . . . . . -
Page 10: Assembly
1 . Align the Support Foot (#30) with the holes in the front of the frame . 2 . Insert an M8x65 screw (#26) through each hole from the top . 3 . Secure each screw with an M8 nut (#29) from below . REV 75520-20121219... -
Page 11: Add Engine Oil
The engine is equipped with a low oil shut-off and filling . will stop when the oil level in the crankcase falls below the threshold level . NOTE Check oil often during the break-in period . Refer to the Maintenance section for recommended service intervals . REV 75520-20121219... -
Page 12: Attach The Pressure Gun
Rotate the base of the hose connection until secure . run the engine to fuel starvation and drain the tank Tighten connection . DO NOT OVER TIGHTEN . when the equipment is not in use for more than 30 days . REV 75520-20121219... -
Page 13: Operation
. 5 . Pull the starter cord slowly until resistance is felt and then pull rapidly . SEE NOTE. 6 . As engine warms up, move the choke lever (Item C) to “Run . ” REV 75520-20121219... -
Page 14: High Pressure Wash
3 feet . DO NOT point the gun at any animal, human, or surface to avoid any damage and/or injury caused by hot and/or pressurized water NOTE It is recommended that the inlet water temperature not exceed 104º F (40º C) . REV 75520-20121219... -
Page 15: Low Pressure Wash
7 . Before overnight storage, long term storage, or diluted 1:12 . Approximately 21oz . of detergent will be transporting unit, disconnect the water supply and consumed from the tank for every minute sprayed . turn off the fuel supply valve . REV 75520-20121219... -
Page 16: Stopping The Engine
. In the event that the pump gets too hot, a thermal relief valve will open to release the hot water . Running the unit without spraying water can damage pump components and will void the warranty . REV 75520-20121219... -
Page 17: Maintenance And Storage
5 . Saturate in clean engine oil . in the dipstick while checking . 6 . Squeeze in a clean, absorbent cloth to remove all excess oil . 7 . Place the filter in the assembly . 8 . Reattach the air filter cover . REV 75520-20121219... -
Page 18: Cleaning
Contact our help line at 1-877-338-0999 to locate the flush with water . (B) nearest Champion Power Equipment certified service dealer for your maintenance needs . Every time of use or daily... -
Page 19: Engine Stored For Over 30 Days
. Pull the recoil several times until antifreeze equipment is not in use for more than 30 days . comes out of the pump outlet . REV 75520-20121219... -
Page 20: Specifications
10% by volume . Use 10W-30 automotive oil . Oil capacity is up to 0 .63 qt . (0 .6 L) . Please reference the following chart for recommended oil types for use in the pressure washer . REV 75520-20121219... -
Page 21: Troubleshooting
Pump will build pressure with each pull . Pull gun trigger after 2 pulls of recoil, to release pump pressure . for further technical support: Technical Service Mon – Fri 8:30 AM – 5:00 PM (PST/PDT) Toll Free: 1-877-338-0999 tech@championpowerequipment .com REV 75520-20121219... -
Page 22: Pressure Washer Parts Diagram
75520 ENGLISH SPECIfICATIONS Parts Diagram REV 75520-20121219... -
Page 23: Pressure Washer Parts List
24 TR4032-H76-0000 Wheel Roll Pin 10" Wheel 10x1 .75(Hub 25 TD4014-Z63-0000 grey) Bolt M8×65/GB5789/Blue- 26 B057890008006570B White Tinted 27 TR4031-H76-0000 Wheel Bushing 28 TWC117-C27-0002 Clamp B Nut M8/GB889/Blue-White 29 B008890008000000B Tinted 30 TR4070-H76-01006X Foot 31 TR4014-H76-0000 Foot Rubber Pad REV 75520-20121219... -
Page 24: Engine Parts Diagram
75520 ENGLISH SPECIfICATIONS Engine Parts Diagram REV 75520-20121219... -
Page 25: Engine Parts List
24620-LC90-0100 GOVERNOR GEAR/SHAFT ASSEMBLY T2999904000800080 COMPOSITE TUBING 91521-07001400000 DOWEL PIN φ7×14 61182-QD03-0000 RUBBER PAD 91521-09001400000 DOWEL PIN φ9×14 61101-LZ4A-0000 COMPOSITE TUBING 90208-LC90-0100 CRANKCASE COVER GASKET 6114Q-LZ4A-0000 RUBBER SLEEVE 12301-LC90-0002 CRANKCASE COVER T1107025004125600 OIL SEALφφ25×φ41 .25×6 14311-LC90-0000 DIPSTICK ASSEMBLY REV 75520-20121219... -
Page 26: Warranty
– Cosmetic defects such as paint, decals, etc . Warranty Qualifications – Wear items such as filter elements, o-rings, etc . Champion Power Equipment (CPE) will register this – Accessory parts such as starting batteries, and warranty upon receipt of your Warranty Registration Card and a copy of your sales receipt from one of CPE’s retail... - Page 27 The United States Environment Protection Agency (U.S. EPA.) and the California Air Resources Board (CARB) Emission Control System Warranty Your Champion Power Equipment (CPE) engine complies with both the U.S. EPA and state of California Air Resources Board (CARB) emission regulations.
- Page 28 EMISSION CONTROL SYSTEM WARRANTY The following are specific provisions relative to your Emission Control System (ECS) Warranty Coverage. 1. APPLICABILITY: This warranty shall apply to 1995 and later model year California small off-road engines (for other states, 1997 and later model year engines). The ECS Warranty Period shall begin on the date the new engine or equipment is delivered to its original, end-use purchaser, and shall continue for 24 consecutive months thereafter.
- Page 29 You must take your CPE engine or the product on which it is installed, along with your warranty registration card or other proof of original purchase date, at your expense, to any Champion Power Equipment dealer who is authorized by Champion Power Equipment, Inc. to sell and service that CPE product during his normal business hours.