Subscribe to Our Youtube Channel
Related Manuals for Champion Power Equipment C24065
Summary of Contents for Champion Power Equipment C24065
- Page 1 C24065 Rev C24065-20080409 Owner’s Manual and Operating Instructions 2700 PSI – 2.7 GPM PRESSURE WASHER...
-
Page 3: Table Of Contents
Table of Contents Introduction ........1 Storage ........... 15 Pressure Washer ........1 Engine Storage ........15 Accessories ..........1 Pressure Washer Storage ......15 This Booklet ..........1 Specifications ......... 16 Manual Conventions ...... -
Page 5: Introduction
Introduction Introduction Accessories Champion Power Equipment manufactures Congratulations on your purchase of a and sells accessories designed to help you Champion Power Equipment pressure get the most from your purchase. To find out washer. CPE designs and builds pressure more about our accessories, please visit our washers to strict specifications. -
Page 6: Manual Conventions
NOTE If you have questions regarding your pressure WARNING washer, we can help. Please call our help line at 1-877-338-0999. WARNING indicates a potentially hazardous could situation which, if not avoided, result in death or serious injury. Rev C24065-20080409... -
Page 7: Safety Rules
Traumatic amputation or severe laceration can result. Keep hands and feet away from rotating parts. Tie up long hair and remove jewelry. Operate equipment with guards in place. DO NOT wear loose-fitting clothing, dangling drawstrings or items that could become caught. Rev C24065-20080409... - Page 8 • Do not remove fuel tank cap or fill fuel tank while engine is hot or running (allow engine to cool two minutes before refueling). Always fill the tank slowly. • Never disconnect the high pressure discharge hose from the machine while the system is pressurized. Rev C24065-20080409...
- Page 9 If water has frozen in the pressure washer, thaw the pressure washer in a warm room before starting. DO NOT pour hot water on or into the pump; internal parts will be damaged and your warranty will be voided. Rev C24065-20080409...
-
Page 10: Controls And Features
High Pressure Pump (8) – gas-engine driven wobble plate pressure pump Choke (4) – Used to start the engine Wand Assembly (9) – Hose, Gun and Recoil Starter (5) – Used to start the High Pressure Wand for power washing. engine Rev C24065-20080409... -
Page 11: Parts Included
Controls and Features Parts Included Your C24065 Gasoline Powered Pressure Washer ships with the following parts: Hose Kit Pressure Gun 1 piece Wand 1 piece Hose 1 piece Wheel Kit Axle Sleeve 2 pieces 8” Solid Wheel 2 pieces Washer, Nut, Bolt... -
Page 12: Assembly
3. Place axle sleeve inside of wheel. Place 1 washer on the bolt, and send it through wheel. Place other washer on, then send bolt through mounting bracket. Secure and tighten with lock nut. 4. Repeat step 3 to attach the second wheel. Rev C24065-20080409... -
Page 13: Add Engine Oil
Use clean, fresh, regular unleaded fuel with a minimum octane rating of 85. Detergents can only be applied at low pressure 2. DO NOT mix oil with fuel. setting. 3. Clean the area around the fuel cap. 4. Remove the fuel cap Rev C24065-20080409... -
Page 14: Operation
Distance from Cleaning Surface The distance between the spray nozzle and the cleaning surface is another factor that affects the impact force of the water. The impact force of the water increases as the Rev C24065-20080409... -
Page 15: Low Pressure Wash
This 6. Re-engage the trigger safety latch. method prevents the detergent from sliding 7. Before overnight storage, long term down and causing streaks. Begin high storage, or transporting unit, disconnect Rev C24065-20080409... -
Page 16: Operating Tips
CAUTION Running the unit for more than one minute without spraying water causes heat to build up in the pump. Running the unit without spraying water can damage pump components and will void your warranty. Rev C24065-20080409... -
Page 17: Maintenance
6. Dispose of used oil at an approved waste management facility. Use a damp cloth to clean exterior surfaces of the engine. Use a soft bristle brush to remove dirt and oil. Use an air compressor (25 PSI) to clear dirt and debris from the engine. Rev C24065-20080409... -
Page 18: Adjustments
(paper clip) to loosen up any particles. Check/Adjust valve clearance * Clean fuel tank and filter * Every 3 years Replace fuel line To be performed by knowledgeable, experienced owners or Champion Power Equipment certified service dealers Rev C24065-20080409... -
Page 19: Storage
3. Clean the pressure washer according to suction in the pump housing. Pull the the instructions in the Maintenance recoil several times until antifreeze section. comes out of the pump outlet. 4. Store the unit in a clean, dry area out of direct sunlight. Rev C24065-20080409... -
Page 20: Specifications
25 inches (63.5 cm) Width 17 inches (43.2 cm) Length 33 inches (83.8 cm) Fuel Fuel capacity is 0.97 US gallons (3.67 L). Use regular unleaded gasoline with a minimum octane rating of 85. Oil capacity is 0.63 qt (0.6 L). Rev C24065-20080409... -
Page 21: Pressure Washer Parts Diagram
Specifications Pressure Washer Parts Diagram Rev C24065-20080409... -
Page 22: Pressure Washer Parts List
Upper Piston ST29QXG-3200019 Fixed Injector ST29QXG-3200020 O-Ring 4.5×1.8 ST29QXG-3200021 Steel Ball 5.5/9Cr18 ST29QXG-3200022 Small Spring ST29QXG-3200023 Screw Jacket ST29QXG-3200024 Outlet Connector ST29QXG-3200025 O-Ring 15×1.8 ST29QXG-3200026 O-Ring 12.5×1.8 ST29QXG-3200027 Unilateral Valve Spring ST29QXG-3200028 Unilateral Valve Core ST29QXG-3200029 O-Ring 4×2.65 Rev C24065-20080409... - Page 23 ST29QXG-03131004-E Support Leg GB5789-86-FB8-45 Flange Bolt M8×45 ST168FD-1151106G Vibration Mount GB5789-86-FB6-25 Flange Bolt M6×25 GB6177-86-N8 Nut M8 ST29QXG-03131003-E Pothook ST29QXG-0001200-I Connect Wand GB6177-86-N6 Nut M6 GB5789-86-FB6-35 Flange Bolt M6×35 ST29QXG-0001100-I Gun Assembly ST29QXG-2200200 Compression Resistance Hose ST29QXG-03131001-E Handle Rev C24065-20080409...
-
Page 24: Engine Parts Diagram
Specifications Engine Parts Diagram Rev C24065-20080409... -
Page 25: Engine Parts List
Radial Ball Bearing 6205 Unsealed ST160F-103-0006 Oil Level Switch Assembly ST160F-105-0001 Governor Weight Holder ST160F-105-0002 Governor Weight Pin ST160F-106-0003 Governor Shaft ST160F-105-0004 Governor Holder Clip ST160F-105-0005 Governor Weight ST160F-105-0006 Governor Shaft Washer ST160F-105-0007 Governor Cover ST168F-2-105-0008-S Crankshaft Complete Rev C24065-20080409... - Page 26 Pillow Block ST168F-104-0014 Pillow Block Stud ST160F-106-0014 Ratchet Guide Spring ST168F-104-0015 Push Rod ST160F-105-0010 GB1667-S5-8 Screw M5×8 ST168F-110-0001 Muffler Protector ST168F-110-0002 Muffler GB41-N-8 Nut M8 ST160F-110-0003 Muffler Packing ST160F-110-0004 Stud Bolt ST168F-104-0017 Shroud 103A ST168F-105-0011 First Ring (Chrome) Rev C24065-20080409...
- Page 27 Second Ring (Black) 103C ST168F-105-0013 Oil Ring Set ST168F-2-105-0014 Piston ST168F-105-0015 Piston Pin Clip ST168F-105-0016 Piston Pin ST168F-105-0017 Connecting Rod ST168F-104-0018 Tappet Lock Nut ST168F-104-0019 Exhaust Rocker Arm ST168F-104-0020 Tappet Adjusting Bolt ST168F-104-0021 Intake Rocker Arm ST168F-104-0022 Rocker Arm Pin Rev C24065-20080409...
-
Page 28: Troubleshooting
Clean nozzle and remove debris Filter on detergent hose is clogged Clean with warm water or replace Garden hose connection leaks Loose fittings Tighten Missing/worn-out rubber washer Replace rubber washer Spray wand leaks Spray wand not properly attached Tighten all connections Rev C24065-20080409... -
Page 29: Warranty
This warranty will not apply to parts and/or Warranty Qualifications labor if this pressure washer is deemed to Champion Power Equipment (CPE) will have been misused, neglected, involved in an register this warranty upon receipt of your accident, abused, loaded beyond the Warranty Registration Card and a copy of pressure washer’s limits, modified, installed... -
Page 30: Contact Information
Contact Information Address Champion Power Equipment, Inc. Customer Service 10006 Santa Fe Springs Rd. Santa Fe Springs, CA 90670 Customer Service Mon – Fri 8:30 AM – 5:00 PM (PST/PDT) Toll Free: 1-877-338-0999 Fax no.: 1-562-236-9429... - Page 31 The California Air Resources Board (CARB) and the United States Environment Protection Agency (U.S. EPA.) Emission Control System Warranty Your Champion Power Equipment (CPE) engine complies with both the U.S. EPA and state of California Air Resources Board (CARB) emission regulations. YOUR WARRANTY RIGHTS AND OBLIGATIONS: The California Air Resources Board, US EPA AND CPE are pleased to explain the Federal and California Emission Control Systems Warranty on your 2005 and later, small off-road engine.
- Page 32 Any CPE Authorized and approved emission-related replacement part may be used in the performance of any ECS Warranty maintenance or repair and will be provided without charge to the owner. Such use shall not reduce CPE’s warranty obligation. Rev C24065-20080409...
- Page 33 Champion Power Equipment dealer who is authorized by Champion Power Equipment, Inc. to sell and service that CPE product during his normal business hours. Claims for repair or adjustment found to be caused solely by defects in material or workmanship will not be denied because the engine was not properly maintained and used.
-
Page 34: Notes
Notes Notes Rev C24065-20080409...
Need help?
Do you have a question about the C24065 and is the answer not in the manual?
Questions and answers
On off switch I have not used in long time…press up or down to turn on to start? Thanks
To operate the on/off switch for Champion Power Equipment part number C24065:
- To turn the engine ON: Flip the engine switch to the “ON” position.
- To turn the engine OFF: Turn the ignition switch to the “Off” position.
This answer is automatically generated