Operation; Pressure Washer Location; Before Starting The Engine; Wireless Remote Start - Champion Power Equipment 71320 Owner's Manual And Operating Instructions

71320
ENGLISH

Pressure Washer location

This pressure washer must have at least five feet of
clearance from combustible material . Leave at least
three feet of clearance on all sides of the pressure
washer to allow for adequate cooling, maintenance and
servicing . Place the pressure washer in a wellventilated
area . DO NOT place the pressure washer near vents
or intakes where exhaust fumes could be drawn into
occupied or confined spaces . Carefully consider wind and
air currents when positioning pressure washer .

before Starting the Engine

1 . Turn the water ON .
2 . Pull the trigger on the pressure gun to purge all
air from the pump and hose . This may take several
minutes .
3 . Do not start the engine until a steady stream of water
is flowing from the nozzle .

Wireless Remote Start

Wireless remote starting is only possible within 80 feet of
the pressure washer .
Do not attempt to adjust the carburetor choke . The remote
system will automatically close and open the choke .
1 . Make certain the pressure washer is on a flat, level
surface .
2 . Press the Ignition Switch to "ON" .
3 . Press the Battery Switch to "ON" .
4 . Turn the Fuel Valve to the "ON" position . (see below)
5 . To start the engine, press and release the "START"
button on the handheld Remote Control device . DO
NOT hold the button down, only press the button
once . The engine will attempt to start 6 times .
6 . If the pressure washer fails to start, check the
battery condition and cable connections .
Starting the Engine without Remote
1 . Make certain the pressure washer is on a flat, level
surface .
2 . Turn the Fuel Valve to the "ON" position .
3 . Press the Battery Switch to "ON" .
4 . ELECTRIC START: Press and hold the ignition switch
to the "START" position . Release as the engine
begins to roll over . If the engine fails to start within
five seconds, release the switch and wait at least ten
seconds before attempting to start the engine again .
5 . RECOIL START: Pull the starter cord slowly until
resistance is felt and then pull rapidly .
NOTE
If the engine does not start after 2 pulls, relieve
pump pressure by pulling the trigger on the pressure
washer gun .
NOTE
If the engine starts but does not run make certain
that the pressure washer is on a flat, level surface .
The engine is equipped with a low oil sensor that will
prevent the engine from running when the oil level
falls below a critical threshold .

OPERATION

12
REV 71320-20120305