Table of Contents
Advertisement
71320
ENGLISH
Air filter
1 . Remove the snap-on cover holding the air filter to
the assembly .
2 . Remove the foam element .
3 . Wash in liquid detergent and water . Squeeze
thoroughly dry in a clean cloth .
4 . Saturate in clean engine oil .
5 . Squeeze in a clean, absorbent cloth to remove all
excess oil .
6 . Place the filter in the assembly .
7 . Reattach the air filter cover and snap in place .
Cleaning
CAUTION
DO NOT spray engine with water .
Water can contaminate the fuel system .
Adjustments
CPE recommends that you contact our service line at
1-877-338-0999 for all other service and/or adjustment needs .
Maintenance Schedule
Follow the service intervals indicated in the schedule below .
Service your pressure washer more frequently when
operating in adverse conditions .
Contact our help line at 1-877-338-0999 to locate the
nearest Champion Power Equipment certified service
dealer for your maintenance needs .
Every 8 hours or daily
Check oil level
Clean around air intake and muffler
First 5 Hours
Change oil
Every 50 hours or every season
Clean air filter
Change oil if operating under heavy load or in hot environments
Every 100 hours or every season
Change oil
Clean/Adjust spark plug
Check/Adjust valve clearance *
Clean spark arrester
Clean fuel tank and filter *
Every 250 hours
Clean combustion chamber*
Every 3 years
Replace fuel line
*To be performed by knowledgeable, experienced owners or
Champion Power Equipment certified dealers .
Pressure Washer Maintenance
Make certain that the pressure washer is kept clean and
stored properly . Only operate the unit on a flat, level
surface in a clean, dry operating environment . DO NOT
expose the unit to extreme conditions, excessive dust,
dirt, moisture or corrosive vapours .
CAUTION
DO NOT use a garden hose to clean the pressure washer .
Use a damp cloth to clean exterior surfaces of the
pressure washer .
Use a soft bristle brush to remove dirt and oil .
Use an air compressor (25 PSI) to clear dirt and debris
from the pressure washer .
Inspect all air vents and cooling slots to ensure that they
are clean and unobstructed .
Cleaning Spray Nozzle
Detach the quick connect nozzle from the wand . Use a
small wire rod (paper clip) to loosen up any particles in
the quick connect nozzle and flush with water .
MAINTENANCE
16
REV 71320-20120305
Advertisement
Table of Contents
