Table of Contents
Advertisement
100786 - 3500 PSI PRESSURE WAShER
5. Replace the spark arrester if it is damaged.
6. Position the spark arrestor on the muffler and attach with the
screws removed in step 2.
Failure to clean the spark arrester will result in degraded
engine performance.
Federal and local laws and administrative requirements
indicate when and where spark arrestors are required. When
ordered, spark arrestors are required for operation of this
product in National Forest lands. In California, this product
must not be used on any forest-covered land, brush-covered
land, or grass-covered land unless the engine is equipped with
a spark arrestor.
Adjusting the Governor
Tampering with the factory set governor will void your
warranty.
The air-fuel mixture is not adjustable. Tampering with the
governor can damage your pressure washer and will void your
warranty. CPE recommends that you contact our service line at
1-877-338-0999 for all other service and/or adjustment needs.
Maintenance Schedule
Follow the service intervals indicated in the schedule below.
Service your pressure washer more frequently when operating in
adverse conditions. Contact our help line at 1-877-338-0999 to
locate the nearest Champion Power Equipment certified service
dealer for your maintenance needs.
EVERY 8 HOURS OR DAILY
— Check oil level
— Clean around air intake and muffler
FIRST 5 HOURS
— Change oil
EVERY 50 HOURS OR EVERY SEASON
— Clean air filter
— Change oil if operating under heavy load or in hot
environments
CAUTION
NOTICE
WARNING
EVERY 100 HOURS OR EVERY SEASON
— Change oil
— Clean/adjust spark plug
— Check/adjust valve clearance*
— Clean spark arrester
— Clean fuel tank and filter*
EVERY 250 HOURS
— Clean combustion chamber*
EVERY 3 YEARS
— Replace fuel line*
* To be performed by knowledgeable, experienced owners or Champion Power
Equipment certified dealers.
STORAGE
Refer to the Maintenance section for proper cleaning instructions.
Pressure Washer Storage
1. Allow the pressure washer to cool completely before storage.
2. Turn off the fuel supply at the fuel valve.
3. Clean the pressure washer according to the instructions in
the Maintenance section.
4. Store the unit in a clean, dry area out of direct sunlight.
Engine Stored for Less than 30 Days
1. Allow the engine to cool completely before storage.
2. Clean engine according to the Maintenance section.
3. To extend the fuel storage life add a properly formulated fuel
stabilizer to the tank.
4. Ensure the fuel valve is in the "OFF" position.
Engine Stored for Over 30 Days
1. Add a properly formulated fuel stabilizer to the tank.
2. Run the engine for a few minutes so the treated fuel cycles
through the fuel system and carburetor.
3. Turn the fuel valve to the "OFF" position.
4. Let the engine run until fuel starvation has stopped the
engine. This usually takes a few minutes.
5. The engine needs to cool completely before cleaning and
storage.
25
STORAGE
Advertisement
Table of Contents
