Maintenance And Storage; Engine Maintenance; Oil; Spark Plugs - Champion Power Equipment 76520 Owner's Manual & Operating Instructions

76520
ENGLISH
The owner/operator is responsible for all periodic
maintenance .
WARNING
Never operate a damaged or defective pressure washer .
WARNING
Improper maintenance will void your warranty .
NOTE
Maintenance, replacement, or repair of emission
control devices and systems may be performed by any
non-road engine repair establishment or individual .
Complete all scheduled maintenance in a timely manner .
Correct any issue before operating the pressure washer .
NOTE
For service or parts assistance, contact our help
line at 1-877-338-0999

Engine Maintenance

To prevent accidental starting, remove and ground spark
plug wire before performing any service .

Oil

Change oil when the engine is warm . Refer to the oil
specifi cation to select the proper grade of oil for your
operating environment .
1 . Remove the oil drain plug with a 12 mm socket and
extension .
2 . Allow the oil to drain completely .
3 . Replace the drain plug .
4 . Remove oil fi ll cap/dipstick to add oil .
5 . Add up to 0 .63 qt . (0 .6 L) of oil and replace oil fi ll
cap/dipstick .
6 . Dispose of used oil at an approved waste
management facility .
NOTE
Once oil has been added, a visual check should show
oil about 1-2 threads from running out of the fi ll hole .
If using the dipstick to check oil level, DO NOT screw
in the dipstick while checking .

MAINTENANCE AND STORAGE

Oil Cont'd.

Spark Plugs

1 . Remove the spark plug cable from the spark plug .
2 . Use the spark plug tool that shipped with your
pressure washer to remove the plug .
3 . Inspect the electrode on the plug . It must be clean and
not worn to produce the spark required for ignition .
4 . Make certain the spark plug gap is 0 .7 - 0 .8mm or
(0 .028 - 0 .031 in .) .
5 . Refer to the spark plug recommendation chart when
replacing the plug .
6 . Carefully thread the plug into the engine .
7 . Use the spark plug tool to fi rmly install the plug .
8 . Attach the spark plug wire to the plug .

Air filter

1 . Unscrew wing nuts to remove the air fi lter cover .
2 . Remove the air fi lter .
3 . Separate the foam element and the paper element .
4 . Tap the paper fi lter element to remove dirt and
debris . Use compressed air (25 PSI) to clear debris .
5 . For the foam element: Wash in liquid detergent and
water . Squeeze thoroughly dry in a clean cloth .
6 . Saturate in clean engine oil .
7 . Squeeze in a clean, absorbent cloth to remove all
excess oil .
8 . Reassemble the two elements and reattach .
9 . Reattach the air fi lter cover and tighten wing nuts .
DO NOT OVER TIGHTEN .
0.7 - 0.8 mm
0.028 - 0.031 in.
REV 76520-20120824
14