71320
ENGLISH
Attach the Hose Hanger
1 . Slide Hose Hanger over the top of frame (recoil side) .
2 . Align Hose Hanger with mounting points on frame .
3 . Slide the bolt (M8x45) through the mount point on
the frame .
4 . Fasten securely with the M8 nut .
Attach the Wand Holder (Clamps)
1 . Align Clamp with mounting points on frame (power
panel side) .
2 . Slide the bolt (M5x12) through the mount point on
the frame .
3 . Fasten securely .
4 . Repeat steps 1-3 for second clamp .
Attach the Gun Holder
1 . Align Gun Holder with mounting point on frame
(Handle side) .
2 . Slide the bolt (M8x50) through the mount point on
the frame .
3 . Fasten securely .
Install the Hoses
Attach the Pressure Gun
1 . Attach the wand with nozzle to the gun .
2 . Connect the high pressure hose to the outlet connection on the
pump .
3 . Connect the other end of the high pressure hose to the gun .
Connect to Garden Hose
Secure a garden hose (not included) to the inlet
connection on the pump .
Attach the Detergent Hose
Connect the clear detergent hose to the brass barb on
the pumps outlet connector .
Place the filter end of the detergent hose into pressure
washer detergent (not included) .
NOTE
Detergents can only be applied at low pressure setting .
ASSEMbly
10
REV 71320-20120305