Table of Contents
Advertisement
Brake Maintenance
Adjusting the Parking Brake
Interlock Switch
1. Stop the machine, move the control levers fully into
the neutral-locked position, set the parking brake,
and remove the ignition key.
2. Remove the bolts securing the front panel and
remove the panel (Figure 66).
Figure 66
1. Front panel bolts
3. Loosen the 2 screws securing the interlock switch.
Figure 67
1. Tab on the brake shaft
2. Parking brake interlock
switch
3. Screws
4. 0.015 to 0.045 inch (0.4 to
1 mm)
4. Move the switch toward the tab on the brake shaft
until the distance between the tab and switch body is
0.015 to 0.045 inch (0.4 to 1 mm) (Figure 67).
5. Secure the switch.
6. Test the adjustment as follows:
A. Ensure that the parking brake is engaged and you
are not sitting on the seat, then start the engine.
B. Move the control levers out of the neutral locked
position.
The engine should stop. If not, recheck the
adjustment you made to the switch.
7. Install the front panel.
41
Advertisement
Table of Contents
