Toro 30381 Operator's Manual page 23

5. Remove the clevis pins and a 5/16" self-tapping
screw pin retainers securing the vertical tube
support assemblies to the rear of the deck frame
(Figure 26).
Figure 26
1. Deck frame
2. Vertical tube support
6. Pivot open the floor plate (Figure 27).
Figure 27
1. Floor plate
3. Clevis pin & screw pin
retainer
7. Slide the drive shaft onto the gearbox shaft
(Figure 28). Install the roll pin and torque the bolts
to 175-225 inch pounds.
1. Drive shaft
2. Gear box
8. Route and connect the hydraulic pressure and tank
hoses to the valve (Figure 29).
1. Control valve
2. Tank hose
9. Install the rear of the deck lift cylinder onto the pivot
pin and secure with the retaining ring (Figure 30).
10. Secure the front of the lift cylinder to the mower
frame with the cylinder pin and screw (Figure 30).
23
Figure 28
3. Bolt
4. Roll pin
Figure 29
3. Pressure hose