Toro 30381 Operator's Manual page 27

Figure 42
1. Rubber mount
12. Tighten the bolts and nuts securing the rear cab
mounts to the ROPS posts (Figure 43 ). Adjust
the floor jack if the bolts are binding and difficult
to remove.
Figure 43
1. Cab mount
2. ROPS post
13. Loosen the jacking bolts and remove the cab jack
tube from the cutouts in the cab floor (Figure 44).
2. 0.875 inch (2.2 cm)
3. Bolts & nuts
4. ROPS post
1. Jacking bolts
14. Connect the hydraulic pressure hose to the valve
hard line and the tank hose to the valve (Figure 45).
Retain the hose plugs for the summer change over.
Note: Make sure the hoses are note kinked or are
rubbing against any moving parts.
Note: Adjust the angle of the fittings to
accommodate the routing of the hoses.
1
2
1. Pressure hose
15. Raise the rear of the machine until 2 jack stands can
be positioned under the rear tube at a height that
supports the rear tires 1 to 3 inches (2.5 to 7.5 cm)
off of the ground.
16. Lower the floor jack so the rear frame rests on the
jack stands. Position the floor jack under the center
of the front lift arm pivot tube.
27
Figure 44
2. Cab jack tube
G009488
Figure 45
2. Tank hose