Table of Contents
Advertisement
Operating the Parking Brake
Always set the parking brake when you stop the
machine or leave it unattended.
Setting the Parking Brake
1. Move the motion control levers (Figure 14) out to
the neutral locked position.
2. Pull up and back on the parking brake lever to set
the parking brake (Figure 10). The parking brake
lever should stay firmly in the engaged position.
Figure 10
1. Parking brake lever
The parking brake may not hold the machine
parked on a slope and could cause personal
injury or property damage.
Do not park on slopes unless the tracks are
chocked or blocked
Releasing the Parking Brake
Push forward and down on the parking brake lever to
release the parking brake (Figure 10).
1. Parking brake lever
Starting the Engine
1. Sit on the seat and fasten the seat belt.
2. Ensure that the motion controls are in the neutral
locked position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the PTO (power take off) switch to the off
position (Figure 12).
1. Ignition switch
2. Throttle control
5. Move the throttle lever midway between the Fast
and Slow positions (Figure 12).
6. Turn the ignition key clockwise to the Run position
(Figure 13).
The glow plug light will turn on for 6 seconds.
16
Figure 11
Figure 12
3. Glow plug light
4. Power take off switch
(PTO)
Advertisement
Table of Contents
