Table of Contents
Advertisement
1. Position the machine on a level surface.
2. Open the hood.
3. Set a drain pan under the oil pan and in line with
the drain plug (Figure 60).
Figure 60
1. Oil filter
4. Clean the area around the drain plug.
5. Remove the drain plug and allow the oil to flow into
drain pan.
6. Remove and replace the oil filter (Figure 60).
7. After the oil is drained, install the drain plug and
wipe up any oil that is spilled.
8. Fill the crankcase with oil; refer to Checking the
Engine Oil Level.
2. Drain plug
Fuel System
Maintenance
Note: Refer to Adding Fuel for proper fuel
recommendations.
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A
fire or explosion from fuel can burn you and
others and can cause property damage.
• Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is off and
is cold. Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add
fuel to the fuel tank until the level is to the
bottom of the filler neck.
• Never smoke when handling fuel, and stay
away from an open flame or where fuel
fumes may be ignited by a spark.
• Store fuel in a clean, safety-approved
container and keep the cap in place.
Servicing the Water Separator
Service Interval: Every 400 hours
Drain water or other contaminants from water separator
(Figure 61) daily. Replace filter canister after every 400
hours of operation.
1. Place a clean container under the fuel filter.
2. Loosen the drain plug on the bottom of the filter
canister.
1. Water separator filter canister
3. Clean the area where the filter canister mounts.
36
Figure 61
Advertisement
Table of Contents
