Mounting A Polar Trac Kit - Toro 30381 Operator's Manual

Figure 30
1. Deck lift cylinder
2. Retaining ring
11. Position the ROPS assembly onto the ROPS posts.
Install the bolt, nut, hair pin cotter and pin securing
each ROPS assembly to the ROPS posts (Figure 31).
Figure 31
1. ROPS
2. Pin
3. Cotter pin
12. Start the machine, raise and lower the deck. Check
for leaks and make sure the hoses do not rub against
the frame.

Mounting a Polar Trac Kit

1. Remove the traction unit from the shipping pallet.
2. Place a jack stand under each wheel motor and a
floor jack under the rear bumper (Figure 32) or
suspend from a over head hoist.
3. Screw
4. Cylinder pin & screw
4. Bolt & nut
5. ROPS post
1. Rear bumper
3. Remove the two screws securing the winter frame
floor plate cover to the floor and remove the plate
(Figure 33).
1. Floor plate cover
4. Carefully roll the winter frame assembly into
position while routing the drive shaft through the
frame tube (Figure 34).
24
Figure 32
2. Floor jack
Figure 33
2. Mounting screws