Storage - Toro 07379 Operator's Manual

Industrial utility vehicle with bed
Hide thumbs Also See for 07379:
Table of Contents

Advertisement

Storage

1. Position the machine on a level surface, set the parking
brake, stop the engine, and remove the ignition key.
Note: Put it in a safe place out of the reach of children.
2. Clean dirt and grime from the entire machine, including
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not use high pressure
water to wash the machine. Pressure washing
may damage the electrical system or wash away
necessary grease at friction points. Avoid excessive
use of water, especially near the control panel,
lights, engine, and the battery.
3. Inspect the brakes; refer to Checking the Brake-fluid
Level (page 18).
4. Service the air cleaner; refer to Servicing the Air
Cleaner (page 30).
5. Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
6. Grease the machine.
7. Change the engine oil; refer to Changing the Engine
Oil and Filter (page 31).
8. Flush the fuel tank with fresh, clean diesel fuel.
9. Secure all fuel system fittings.
10. Check the tire pressure; refer to Checking the Tire
Pressure (page 18).
11. Check anti freeze protection and add a 50/50 solution
of water and anti freeze as needed for expected
minimum temperature in your area.
12. Remove the battery from the chassis, check the
condition of the battery, and charge it fully; refer to
Servicing the Battery (page 33).
Note: Do not connect the battery cables to the battery
posts during storage.
Important: The battery must be fully charged to
prevent it from freezing and being damaged at
temperatures below 0°C (32°F). A fully charged
battery maintains its charge for about 50 days
at temperatures lower than 4°C (40°F). If the
temperatures will be above 4°C (40°F), check the
water level in the battery and charge it every 30
days.
13. Check and tighten all the bolts, nuts, and screws. Repair
or replace any part that is damaged.
14. Paint all the scratched or bare metal surfaces.
Paint is available from your Authorized Service
Distributor.
15. Store the machine in a clean, dry garage or storage area.
16. Cover the machine to protect it and keep it clean.
44

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman hdx-d

Table of Contents