Table of Contents
Advertisement
Replacing the Hydraulic Filter
Service Interval: After the first 10 hours
Every 800 hours
Important: Use of any other filter may void the warranty
on some components.
1. Position the machine on a level surface, stop the
engine, engage the parking brake, and remove the key
from ignition switch.
2. Clean the area around filter mounting area.
3. Place a drain pan under the filter and remove the filter
(Figure 65).
Figure 65
1. Hydraulic filter
4. Lubricate the gasket on the new filter.
5. Ensure that the filter mounting area is clean.
6. Screw the filter on until the gasket contacts the
mounting plate, and tighten the filter 1/2 turn.
7. Start the engine and let it run for about 2 minutes to
purge air from the system.
8. Stop the engine and check the hydraulic-oil level and
for leaks.
2. High-flow hydraulic filter
Cleaning
Washing the Machine
The machine should be washed as needed. Use water alone
or with a mild detergent. A rag may be used when washing
the machine, however the hood will loose some of its luster.
Important: Do not use power washing equipment to
wash the machine. Power washing equipment may
damage the electrical system, loosen important decals,
or wash away necessary grease at friction points. Avoid
excessive use of water near the control panel, engine,
and battery.
43
Advertisement
Table of Contents
