Converting The Speedometer - Toro 07379 Operator's Manual

Note: Adjust again if it is necessary.
6. Connect the return spring to the clutch lever.
Important: Ensure that the rod end is positioned
squarely on the ball, not twisted, and remains
parallel to the clutch pedal after the jam nut is
tightened (Figure 61).
1. Clutch-cable rod end
2. Clutch pedal
Note: The clutch free play should never be less than
19 mm (0.75 inch).

Converting the Speedometer

You can convert the speedometer from mph to kpm or kph
to mph.
1. Position the vehicle on a level surface, stop the engine,
engage the parking brake, and remove the key from
the ignition switch.
2. Remove the hood; refer to Removing the Hood (page
28).
3. Locate the 2 loose wires next to the speedometer
(Figure 62).
Figure 61
3. Rod end jam nut
4. Parallel
1. Speedometer (forward
face)
2. Plug
4. Remove the connector plug from the harness wire and
connect the wires together (Figure 62).
Note: The speedometer will switch from mph to kph.
Retain the plug in order to convert the speedometer
to mph.
5. Install the hood; refer to Installing the Hood (page 28).
41
Figure 62
3. Speedometer wires