Lubrication; Greasing Bearings And Bushings - Toro 07379 Operator's Manual

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours (Lubricate more frequently
in heavy duty applications)
The vehicle has grease fittings that must be lubricated
regularly with No. 2 general-purpose, lithium-base grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) (Figure 29)
•
Spring tower (2) (Figure 30)
•
Clutch (1), accelerator (1), brake (qty. 1) (Figure 31)
•
Accelerator arm (1) (Figure 32)
•
U-joint (18) and 4 wheel drive shaft (3) (Figure 33)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump the grease into each bearing or bushing.
3. Wipe off the excess grease.
Figure 29
29
Figure 30
Figure 31
Figure 32