Table of Contents
Advertisement
Figure 46
1. Front of vehicle
2. 0 ± 3 mm (0 ± 0.12 inch)
front to rear of tire
3. Adjust the center-to-center distance as follows:
A. Loosen the jam nut at the center of the tie rod
(Figure 47).
Figure 47
1. Tie rods
B. Rotate the tie rod to move the front of the tire
inward or outward to achieve the center to center
distances from front to back.
C. Tighten the tie rod jam nut when the adjustment
is correct.
D. Check to ensure that the tires turn an equal
amount to the right and to the left.
Note: If the tires do not turn equally, refer to
the Workman service manual for the adjustment
procedure.
3. Center to center distance
2. Jam nuts
Cooling System
Maintenance
Removing Debris from the
Cooling System
Service Interval: Before each use or daily (Clean more
frequently in dirty conditions.)
1. Turn the engine off.
2. Clean the engine area thoroughly of all debris.
3. Remove the 5 bolts securing radiator screen/guard to
the radiator (Figure 48).
Note: The guard is not shown in the figure. (Figure
48).
1. Radiator screen
2. Mounting bolts
4. Remove the screen/guard (Figure 48).
5. If equipped with a high flow hydraulic kit, rotate the
latches and pivot the oil cooler away from the radiator
(Figure 49).
1. Radiator housing
2. Oil cooler
36
Figure 48
Figure 49
3. Latches
Advertisement
Table of Contents
