Table of Contents
Advertisement
3.
Pivot the top of the hood forward and unplug the
wire connectors from the headlights
4.
Remove the hood.
Installing the Hood
1.
Connect the lights.
2.
Insert the top mounting tabs into the frame slots
(Figure
35).
3.
Insert the lower mounting tabs into the frame
slots
(Figure
35).
4.
Ensure that the hood is fully engaged in the top,
sides, and bottom grooves.
Lubrication
(Figure
35).
Greasing the Bearings and
the Bushings
Service Interval: Every 100 hours (lubricate
Grease Type: No. 2 lithium grease
Important:
universal shaft bearing crosses, pump grease
until it comes out of all 4 cups at each cross.
1.
Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2.
With a grease gun, apply grease into the grease
fittings on the machine.
3.
Wipe any excess grease off the machine.
The grease fitting locations and quantities are as
follows:
•
Ball joints (4); refer to
•
Pivot mounts (2); refer to
•
Steering cylinder (2); refer to
•
Tie rods (2); refer to
37
more frequently in heavy-duty
applications).
When greasing the drive shaft
Figure 36
Figure 36
Figure 36
Figure 36
Figure 36
g010360
Advertisement
Table of Contents
