Installing The Cutting Unit To The Traction Unit - Toro 04042 Operator's Manual

1
1. Flange-head bolt
3
Installing the Cutting Unit to
the Traction Unit
Parts needed for this procedure:
2 Bolt (3/8 x 3/4 inch)
Procedure
Note: To install the weight rod onto your machine, refer to
the installation instructions in your Cutting Unit Operator's
Manual.
1. Place the mower on its drums on a level surface.
2. Lower the kick stand and push in the locking pin to
lock the kick stand in the service position
Note: Allow the machine to rest on the locked
kickstand.
Note: Place the kickstand in this position whenever
you remove the reel. This will keep the machine from
tipping backward onto the handle.
2
G026124
Figure 5
2. Weight rod
(Figure
1
2
3
1. Kickstand—storage
position
2. Locking pin
3. Push the cutting unit under the traction unit and to the
left to engage the transmission coupling
1. Transmission coupling
4. Maneuver the traction unit frame
6).
until it engages the cutting unit pivot arms.
12
Figure 6
3. Kickstand—service
position
(Figure
Figure 7
(Figure 8) forward
G017356
7).