Table of Contents
Advertisement
Refer to the Installation Instructions included
with the Battery Shipping Kit (a PDF file of
these instructions is available at no charge from
www.toro.com).
2. Cut the cable tie securing the battery charger to the
battery base on the machine and remove the charger.
3. Disconnect the small connector on the pack to machine
wiring harness from the main wiring harness
14).
4. Remove the tall nut that secures the rear of the battery
base to the machine frame
Figure 10
1. Tall nut
5. Loosen the 2 pivot bolts/nuts a half turn each
11).
4
5
Figure 11
1. Battery pack
2. Battery platform
3. Bolt and washer
6. Raise the battery platform until the locking holes in the
base and frame align
Note: Slide a screw driver or other steel rod through
the holes to hold the platform in the raised position.
(Figure
(Figure
10).
1
1
2
G017295
4. Pivot bolts
5. Locking holes
(Figure
11).
7. Place the battery pack on the base with the connector
port toward the rear of the machine.
8. Secure the battery pack to the base using 6 bolts (5/16
x 1/2 inch) and washers.
Note: Torque each bolt to 11.3 to 14 N-m (100 to
130 in-lb).
9. Line up the tabs on the inside of the harness power
plug with the slots in the battery pack receptacle.
Note: Press the harness connector into the battery
connector
3
4
G017238
(Figure
G017236
1. Battery-pack receptacle
2. Locking collar
3
14
(Figure 12
and
Figure
13).
1
2
Figure 12
3. Pack the machine to the
wiring-harness plug
4. Bolt securing the battery
pack
Figure 13
G017358
Advertisement
Table of Contents
