Belt Maintenance; Inspecting The Reel Drive Belt; Accessing The Transmission Cover Hole - Toro 04042 Operator's Manual

Belt Maintenance

Inspecting the Reel Drive Belt

Service Interval: Every 1,000 hours
Make sure the reel drive belt is properly tensioned to ensure
proper operation of the machine and unnecessary wear.
1. Turn off the machine and disconnect the battery pack.
2. Loosen the flange bolt securing the belt cover and
remove the belt cover to expose the belt
Figure 45
1. Belt cover
3. To adjust the belt tension:
A. Loosen the bearing housing mounting nut
46).
Figure 46
1. Bearing housing mounting
nut
2. Reel drive belt
B. Using a 16 mm (5/8 inch) wrench, rotate the
bearing housing to make sure it operates freely.
C. Clean any debris from inside the belt compartment
and from around the compression spring
46).
D. Make sure the compression spring is applying the
proper tension on the belt.
(Figure 45).
g018273
(Figure
3. Compression spring
(Figure
E. Tighten the bearing housing mounting nut.
F. Install the belt cover.
Accessing the Transmission
Cover Hole
Remove the rubber plug
front of the transmission if you need to access the reel clutch.
Important: Do not operate the machine with the rubber
plug removed.
1
2
1. Engage/disengage shaft
38
(Figure 47) from the hole in the
G017387
Figure 47
2. Rubber hole plug