Table of Contents
Advertisement
Electrical System
Maintenance
Servicing the Battery Pack
The only user serviceable parts in the battery pack are
the labels and the fuse. If you attempt to open the main
compartment of the battery pack you will void your warranty.
If you are having problems with your battery pack, contact
your Authorized Toro Distributor for help.
WARNING
The battery pack contains high voltage which could
burn or electrocute you.
• Never attempt to open the battery pack.
• Do not place anything in the connector on
the battery pack other than the wire harness
connector that came with the product.
• Use extreme care when handling a battery pack
with a cracked case.
• Only use the charger designed for the battery
pack
Shipping the Battery Pack for
Service
If your battery pack requires service, contact your Authorized
Toro Distributor for assistance. If you must ship the
battery pack, obtain the Battery Shipping Kit, part
number 120-4600. This kit contains the proper tape, labeling,
and instructions you will need to ship the battery pack.
Important: Failure to correctly pack and label the
battery pack for shipping can result in large fines.
Refer to the instructions included in the Battery
Shipping Kit, part number 120-4600, available for free on
www.Toro.com.
Replacing Fuses
If the machine will not turn on, even after charging, check
the machine fuses as follows:
1. Turn off the machine and disconnect the battery pack.
2. Remove the 2 rear screws from the electrical box and
loosen the 2 upper screws then remove the box cover
(Figure
39).
1
3
1. Electrical box
2. Upper screws
3. Check the fuses in the fuse block
1
2
3
1. 30 amp fuse
2. 3 amp fuse
•
If any of the fuses are blown, replace them with
a fuse of the appropriate voltage and amperage
(Figure
40).
Important: All fuses on the machine are rated
for 80 volts. Do not use 12 volt automotive
fuses.
•
If the fuses are not blown, check the battery pack
fuse as follows:
A. Raise the battery platform; refer to
the Battery Pack (page
B. Remove the fuse cover
35
2
G017423
Figure 39
3. Rear screws
(Figure
40).
G017424
Figure 40
3. Open slot
5 Installing
13).
(Figure
41).
Advertisement
Table of Contents
