Adjusting The Handle Angle; Adjusting The Throttle Control; Turning On The Machine; Turning Off The Machine - Toro 04042 Operator's Manual

Adjusting the Handle Angle

1. Remove the hairpin cotters from the handle retainers
on each side of the mower
g017355
1. Hairpin cotter
2. While supporting the handle, remove the hairpin
cotters from each side and pivot the handle to the
desired operating position
3. Install the handle retainers and hairpin cotters.

Adjusting the Throttle Control

1. Remove the console cover.
2. Loosen the 2 fasteners securing the throttle control
(Figure 31).
1. Fasteners
3. Adjust the throttle control to the desired position.
4. Tighten the throttle-control fasteners.
(Figure 30).
Figure 30
2. Handle retainer
(Figure 30).
Figure 31
2. Throttle control
5. Install the previously removed console cover.

Turning on the Machine

1. Ensure that the T-handle connector on the main
wiring harness is connected to the main power supply
connector
2. Ensure that the traction and reel drive levers are in
neutral.
1
3. Move the key switch to the Start position and hold it
until the InfoCenter LCD display lights up, then release
it to the Run position.
2

Turning off the Machine

1. Disengage the traction and reel drive controls.
2. Turn the key switch to the Off position and remove
the key.
23
(Figure 15).