Installing The Kickstand (For Gr800 And Gr1600) - Toro 04054 Greensmaster 800 Operator's Manual

4. Squeeze the handle ends inward and install them on the
mounting pins (Figure
G017601
Figure 3
1. Handle end
2. Bolt, washer, and lockwasher
5. Secure the handle ends to the mounting pins with the
bolts, washers, and lockwashers provided
6. Secure the bottom of the handle arms to each side
of the mower with the bolts and locknuts previously
removed (Figure 3). Ensure that you install the
bushings in the handle arm mounting holes.
7. Secure the handle arms to the rear of the frame with
the hairpin cotters and ring pins previously removed
(Figure 3).
8. Secure the cables and wire harness to the handle with
cable ties (Figure 4).
1
Figure 4
1. Cable ties
3).
(Figure
G017590
Adjusting the Handle
1. Remove the hairpin cotters from the ring pins on each
side of the mower
2. While supporting the handle, remove the ring pins
from each side and raise or lower the handle to the
desired operating position
3. Install the ring pins and hairpin cotters.
2
Installing the Kickstand (For
GR800 and GR1600)
Parts needed for this procedure:
1 Kickstand assembly
1 Spring
3).
Procedure
Note: The fasteners are shipped loosely installed on the
kickstand assembly.
1. On the GR1600 only, connect the spring stud to the
right hand side of the kickstand
bolt, washer, and flange-head nut provided.
1
1. Bolt
2. Spring stud
2. Hook the spring into the hole in the spring bracket and
onto the spring stud while aligning the kick stand with
the mounting holes in the rear frame
11
(Figure 2).
(Figure 2).
(Figure 5) using the
4
3
2
G017948
Figure 5
3. Washer
4. Flange-head nut
(Figure 6).