Electrical System Maintenance; Servicing The Interlock Switch; Brake Maintenance; Adjusting The Service/Parking Brake - Toro 04054 Greensmaster 800 Operator's Manual

Electrical System
Maintenance

Servicing the Interlock Switch

Use the following procedure if the switch needs adjustment
or replacement.
1. Make sure the engine is off and the traction lever is
disengaged and resting against the neutral stop
30).
1
2
4
3
G016989
Figure 30
1. Traction lever
2. Neutral stop
2. Loosen the interlock switch mounting fasteners
30).
3. Place a .032" thick shim between the traction lever and
the interlock switch
4. Tighten the interlock switch mounting fasteners.
Recheck the gap. The traction lever must not contact
the switch.
5. Engage the traction lever and verify that the switch
loses continuity. Replace if required.
3. Interlock switch
4. .032" Gap
(Figure 30 ).

Brake Maintenance

Adjusting the Service/Parking
Brake
If the service/parking brake slips when operated, an
adjustment is required.
1. Engage the service brake, push in on the parking brake
knob and allow the service brake to rest on the parking
(Figure
brake pin
(Figure
2. Using a spring scale, press rearward on the service
brake lever
release when a force of 13.5 to 18 kg (30 to 40 lbs) is
attained. If the parking brake releases before 13.5 to 18
kg (30 to 40 lbs) of force is attained, an adjustment to
the brake cable is required. Proceed to step 3.
26
(Figure 31)
Figure 31
(Figure 32). The parking brake should
G016990