Lubrication; Greasing The Machine - Toro 04054 Greensmaster 800 Operator's Manual

Lubrication

Greasing the Machine

Service Interval: Every 25 hours
Lubricate the 13 grease fittings on the mower using a No. 2
multipurpose lithium base grease. A hand operated grease
gun is recommended for best results.
The grease fitting locations are as follows:
•
2 on the front roller (Figure
•
2 on the reel bearings
•
2 on the drum axles (Figure
•
3 on the differential (Figure
•
2 on the reel countershaft bearings
•
2 on the belt idler pivots
1. Wipe each grease fitting with a clean rag.
2. Pump grease into each fitting until it begins to get
difficult to pump the gun.
Important: Do not apply too much pressure or
grease seals will become permanently damaged.
3. Wipe off any excess grease.
Figure 18
Figure 19
18)
(Figure 18)
19)
19)
(Figure 20)
(Figure 21).
G016993
G016982
22
G016981
Figure 20
Figure 21