Installing The Handle; Installing The Kickstand For Flex 18 Mowers Only - Toro 04019 Operator's Manual

2

Installing the Handle

Parts needed for this procedure:
1 Handle
Procedure
1. Remove the flange lock nut from the bolt and pivot
pin on each side of the mower (Figure 7).
1. Flange lock nut
2. Insert the handle ends through the slots in the handle
support arms (Figure 8).
Figure 6
Figure 7
2. Pivot pin
1. Left handle end
2. Support arm
3. Squeeze the handle ends inward and install them on
the step of the pivot pin (Figure 8).
4. Secure the handle to the bolt and pivot pin with the
flange lock nut (Figure 8).
5. Locate cable tie loosely securing throttle cable to
wire harness. Position cable tie approximately one
inch behind transmission and tighten cable tie.
3
Installing the Kickstand for
Flex 18 Mowers Only
Parts needed for this procedure:
1 Kickstand assembly
1 Spring
1 Small spacer
1 Large spacer
1 Large bolt (M8–1.25 x 100)
1 Small bolt (M8–1.25 x 030)
2 Locknut (M8 x 1.25)
2 Washer (M8)
Procedure
1. Position the kickstand between the tabs on the rear
of the frame.
2. Install a washer (M8) onto the small bolt (M8–1.25
x 030). Install the right side of the kickstand to the
11
Figure 8
3. Pivot pin
4. Locknut