Product Overview; Controls - Toro 04054 Greensmaster 800 Operator's Manual

Product Overview

Controls

2 3
1
G017592
Figure 10
1. Traction drive lever
2. Throttle control
3. On/off switch
4. Hour meter
Throttle Control
The throttle control (Figure
side of the control panel. The lever connects to and operates
the throttle linkage to the carburetor. See
15)for engine speed.
Traction Drive Lever
The traction drive lever (Figure
right side of the control panel. It has two positions: Neutral
and Forward. Pushing the lever forward engages the traction
drive.
Service Brake
The service brake (Figure
side of the control panel. You can use the brake to slow or
stop the machine.
4 5
6 7
5. Service brake
6. Parking brake
7. Operator presence control
(optional)
10) is located on the rear right
Specifications (page
10) is located on the front
11) is located on the top left front
Parking Brake
The parking brake (Figure
service brake. Fully engage the service brake and push the
parking brake knob to allow the service brake to rest on the
parking brake pin. Engage the service brake to release the
parking brake. You must release the brake before the traction
drive is engaged.
On/Off Switch
The on/off switch (Figure
control panel. Move the switch to the On position to start the
engine and the Off position to stop the engine.
Operator Presence Control (Optional)
If equipped, the operator presence control
located on the rear of the handle. Push the operator presence
control against the handle. If equipped, the operator presence
control must be engaged before moving the traction drive
lever or the engine will stop.
14
G016976
Figure 11
12) is located at the base of the
G016977
Figure 12
10) is located on the top of the
(Figure 10) is