Backlapping The Reel; Storage - Toro 04054 Greensmaster 800 Operator's Manual

nylon washer on each side of the side plate boss. Place
a steel washer outside each of the nylon washers.
3. Torque the bolts to 27 to 36 N-m (240 to 320 inch-lb).
4. Tighten the jam nuts until the outside thrust washers
just rotate freely.
5. Tighten the spring tension nut until the spring is
collapsed, then back it off 1/2 turn.
6. Adjust the bedbar; refer to
the Reel (page 32).

Backlapping the Reel

1. Remove the plug in the right reel drive cover
57).
Figure 57
1. Cover plug
2. Insert a 1/2 inch socket extension, connected to the
backlapping machine, into the square hole in the center
of the reel pulley.
3. Backlap according to the procedure in the Toro
Sharpening Reel and Rotary Mowers Manual, Form No.
80-300 PT.
DANGER
Contact with the reel or other moving parts
can result in personal injury.
• Stay away from the reel while backlapping.
• Never use a short handled paint brush for
backlapping. Part No. 29-9100 Handle
assembly complete or individual parts are
available from your local Authorized Toro
Distributor.
Note: For a better cutting edge, run a file across the
front face of the bedknife when the lapping operation
is completed. This will remove any burrs or rough
edges that may have built up on the cutting edge.
4. Install the plug in the cover when finished.
Adjusting the Bedknife to
(Figure

Storage

1. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the shift lever plate and engine.
2. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to the fuel in the tank.
A. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Either stop the engine, allow it to cool, and drain
the fuel tank, or operate the engine until it stops.
C. Restart the engine and run it until it stops. Repeat,
on Choke, until the engine will not restart.
D. Dispose of the fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
3. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
4. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
5. Store the machine in a clean, dry garage or storage area.
Cover the machine to protect it and keep it clean.
38