Toro 04054 Greensmaster 800 Operator's Manual page 27

Figure 32
1. Rear pressure on service brake lever
3. Loosen the retainer securing the V-belt cover and pivot
the cover open (Figure
1
Figure 33
1. V–belt cover
4. To adjust the brake cable tension, proceed as follows.
•
To decrease the cable tension, loosen the front
cable jam nut and tighten the rear jam nut
34). Repeat steps 1 and 2 and readjust if required.
•
To increase the cable tension, tighten the front
cable jam nut and loosen the rear jam nut
34). Repeat steps 1 and 2 and readjust if required.
Note: The adjustment can be performed on the
cable at the jam nut brackets by the control panel
or at the bracket at the base of the engine.
33).
2
G016991
2. Retainer
(Figure
1. Service/Parking brake
cable
5. Close the cover and secure the retainer.
(Figure
27
Figure 34
2. Front jam nut