Shifting The Transmission; 2Wd/4Wd Selector - BOMBARDIER outlander 800 Operator's Manual

Press the start button and hold until
the engine starts.
CAUTION: Do not hold the start
button more than 30 seconds. A
rest period should be observed be-
tween the cranking cycles to let the
starter cool down. Pay attention
not to discharge the battery.
Release the start button immediately
when the engine has started.
NOTE: If the battery is dead, engine
cannot be started. Have the battery
recharged or replaced.

Shifting the Transmission

Let engine idle to warm up.
Apply brakes and select the desired
gear range H or L.
NOTE: The brake must be applied
when the transmission lever is en-
gaged in the park position.
Release brakes.
CAUTION: Make sure parking brake
is fully disengaged before operat-
ing the ATV.
Gradually press the throttle lever to in-
crease engine speed and thus engag-
ing the continuously variable transmis-
sion (CVT).
At the opposite, when the throttle
lever is released, the engine speed
decreases.
Using the Reverse
CAUTION: When changing from
forward to reverse, or vice-versa,
always completely stop the vehicle
and apply the brake prior to moving
the transmission lever.
The same procedures as SHIFTING
THE TRANSMISSION above apply ex-
cept for the following.
Set the transmission lever in RE-
VERSE position.

2WD/4WD Selector

The 4WD mode may be selected
or deselected when the vehicle is
stopped.
CAUTION: The vehicle must be
stopped to engage or disengage
2WD/4WD
damage may occur if selector is en-
gaged or disengaged while driving.
CAUTION: If the rear wheels are
spinning, release the throttle and
wait engine return to the idle before
selecting the 4WD mode.
The 4WD mode is engaged when the
selector is pushed downwards.
V07I0DY
4WD MODE
To deselect the 4WD mode, press the
selector on 2WD.
_____________________
selector. Mechanical
87